DHD series high-pressure down-the-hole drill bit
DHD340A drill bit is a convex high-pressure down-the-hole drill bit, which is mainly used for geological exploration, coal mines, water conservancy and hydropower, railways, construction, etc.
DHD340A drill face characteristics
- Convex Face
This shape is suitable for drilling soft-medium hard rock formations with low-medium wind pressure, and the steel body of the drill bit is not easy to corrode.The drilling speed is faster and the drill body wears less. The characteristic is that the tooth load is low, the wear is not serious, and the drilling speed is fast.
DHD340A drill bit alloy tooth profile selection
- Bullet teeth
Application: The middle tooth of the down-the-hole drill bit is suitable for rocks with medium abrasiveness and medium hardness. Edge teeth can also be used when the rock is relatively soft.
- Button teeth
Application: DTH drill bit side teeth, suitable for abrasive and very hard rock.
DHD340A drill bit introduction
DHD340A down-the-hole drill bits use high-quality steel and best-level alloy steel as raw materials, use special heat treatment technology and advanced cemented carbide inlay technology, so that the drill bit can perform well even on hard rock formations, and at the same time Can save energy.
DHD340A drill bit technical parameters
DHD340A DTH drill bit features advantages
Long bit life
This type of down-the-hole drill is made of alloy steel material, and its quality is effectively guaranteed. Its service life is long, and it is higher than similar products, and its durability is better.
High drilling efficiency
This type of drill uses impact and shear to break rocks. The drill teeth are wear-resistant, so that the drill bit can always remain sharp, thus greatly improving the speed of the tooth.
Good compliance effect
The drill bit of this model has strong wear resistance and excellent gauge performance, which can make the cutting teeth efficiently used.
Wide range of use
The drill bit is suitable for drilling in soft, medium-hard and hard formations. Compared with ordinary drill bits, especially for drilling 6-8 rock formations, the effect is particularly significant.
DHD series products are widely used in water well drilling and hard rock formation protection. In the past 20 years, we have exported this drill bit to many countries, and the feedback is good. You are welcome to contact us, if you need, we can provide all series of drilling equipment and drilling tools.